Conventional Logic Sensor is a multi-functional device suitable for indoor usages with detection capability. It also offers special use for hotel rooms and provides the possibility of use with virtual card function. The device also integrates “Virtual Card Holder”; The application area is the hotel room: through a magnetic sensor mounted on the door and connected to a digital input, accurate presence information is managed. In this way, when it detects that there is no customer in the hotel room, it cuts off the energy of the room and saves energy. For general use areas, it can cut off the energy of the lighting units that control the relevant area by changing the status of the relay only when presence is detected.


 


• To change the operational mode of the device, users must press and hold the configuration button located on the rear panel for a duration of 3 to 15 seconds. The activation of the new mode is visually confirmed through the illumination of red or blue LEDs: red LED for Mode 1 and blue LED for Mode 2 transitions
 

• The sensor's standby time can be adjusted to 1 minute, 5 minutes, 10 minutes, 15 minutes, or 20 minutes by users. There are two methods to set the standby time. The first method involves pressing the configuration button for less than 3 seconds. The second method requires exposing the sensor to high light (at least 900 lux greater than the ambient light intensity) for a minimum of 2 seconds, followed by withdrawing the light source within 4 seconds. This process sets the standby time, which is indicated by the LEDs lighting up to the respective level. The pattern and color of the LED illumination vary depending on the Mode and contact type.
 

• If Mode 1 is to be used, the contact type (Normally Open/Normally Close) must be determined by pressing the configuration button for a minimum duration of 15 seconds. Following this period, the contact type is switched. The device is set to Normally Close if it operates with blinking and to Normally Open if it operates without blinking.
 

• Upon each power-up and parameter change, the device activates LEDs according to its current configuration settings.
 

• The default parameters of the device are set to Mode 2 (using only the presence sensor) with a standby time of 5 minutes.

 

Interra Sensor Series

ITR415-2101 // Multi Mid Range Conventional Presence Sensor / Black

Yeniliklerden haberdar olmak için e-bültenimize kayıt olun.